• June 25, 2017, 11:48:09 pm
• Welcome, Guest. Please login or register.
Did you miss your activation email?

!!

TEMAC Forum Guests

Please take the time to Register for the forum, especially if you are a TEMAC club member.

This is one of the most active RC club forums in Ontario. Please participate in the discussion to help our great club to continue to grow.

Author Topic: AS3X  (Read 84 times)

0 Members and 1 Guest are viewing this topic.

Offline Bigstik

  • Captain
  • ****
  • Posts: 272
  • Karma: +2/-2
  • Real Name: John Alan Biggerstaff
AS3X
« on: June 10, 2017, 03:31:33 pm »
At the last float fly, Clairville, there was a discussion started by me, about the ability to alter AS3X setting using your tx. Most there indicated that one must use the programming cable, whereas I believed that one can do it from the tx. The manual, DX7 G2 indicated that one can do it at the tx.
Turns out that one must use the programming cable to change the rate and gain settings in the rx from ABS (absolute) to REL (relative). Then set up the tx telementry to AS3X. Then the gain and heading settings can be changed 'on the fly' so to speak.


Bigstik

Offline Frank v B

  • Ace
  • *****
  • Posts: 1104
  • Karma: +18/-1
  • TEMAC - Assistant to the Assistant Greeter.
  • Real Name: Frank van Beurden
  • TEMAC #: 141
Re: AS3X
« Reply #1 on: June 10, 2017, 07:28:53 pm »
Al,

Thanks for posting the answer.  Remember I am the guy who doesn't even use exponential on any of my airplanes.  I fly it the way the transmitter is programmed.
Flew my E-Flite Rare Bear  (4S, 70 amp ESC) again today which has AS3X as supplied with the plane.  It does make for very smooth flying of a twitchy, overpowered airplane.  I ain't changing a thing on it! :D  I figure if I change the "gain" it will be my loss. ;)

Frank

"Never trade luck for skill"