• February 17, 2020, 01:03:25 pm
• Welcome, Guest. Please login or register.
Did you miss your activation email?

!!

TEMAC Forum Guests

Please take the time to Register for the forum, especially if you are a TEMAC club member.

This is one of the most active RC club forums in Ontario. Please participate in the discussion to help our great club to continue to grow.

Author Topic: Frank's re-build of a Knox Hawkshaw's design/build  (Read 1299 times)

0 Members and 1 Guest are viewing this topic.

Offline Frank v B

  • Ace
  • *****
  • Posts: 2764
  • Karma: +20/-1
  • TEMAC - Assistant to the Assistant Greeter.
  • Real Name: Frank van Beurden
  • TEMAC #: 141
  • Started Flying RC: 1989
Re: Frank's re-build of a Knox Hawkshaw's design/build
« Reply #15 on: October 21, 2019, 09:22:43 pm »
Time to pull this one out again since the flying season is nearing an end*.

In the past week I have completed the following:
- set up the wing and drilled it for the wing bolts.  It now attaches properly and is lined up and square.
- installed the elevator and rudder servos in the fuselage.
- attached the aileron pushrod
- installed the aileron horns and made the pushrods
- had an accident.  The wing fell over and punched a hole through the top of the wing.  Watch the future "how to patch a hole in the wing" post.

Next steps- cover the fuselage.

Frank

* it is just starting for Andy.... but then... he has always been backwards. ;)
"Never trade luck for skill"