SIG Komander

Started by GuyOReilly, April 19, 2019, 03:49:21 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

GuyOReilly

Hello, I am starting to build a SIG Komander.  I plan on installing a E-Flite 46 Outrunner motor, using 3300-4S battery. 
I am looking for a template for the X-mount for the motor so I can drill and add the blind nuts without drilling through a motor mount.
The dimensions I came up with were 50mm centre to centre as per the attached picture.

Are these the correct dimensions for the E-Flite?

Thank you.
Guy O'Reilly

Frank v B

#1
Guy,

Just pulled out my NIB E-Flite Power 46, the original instructions and my digital micrometer.*
Funny that the instructions do not contain the drawings and distances.

Distance between the firewall mounting holes centres- 56.0 mm  (outer holes) Measured diagonally across the centre.
Distance between the motor mounting hole centres- 30.0 mm (inner holes).  Measured diagonally across the centre.

The inner holes are symmetrical for the Power 46.  Some motors are not.

Hope that helps.

Frank

* Bruce will be proud of me! ;D
"Never trade luck for skill"

GuyOReilly

Thank you Frank! :)
This helps.
I too was surprised  :o to see that there were no template or dimensions shown in the instructions.
Guy