DC-6 Print and Build

Started by davidk, December 23, 2022, 03:45:21 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

davidk

Engine Cowls done

sihinch

Oooooo. Nice! Can't wait for this.

bfeist

How the heck did you print that in 1 hours 18 minutes??

GordPayne

The river and panel detail is great! Congrats!
Old Buttonville proverb,"If you have to hit the fence, hit the far fence, not the near fence."

davidk

Quote from: bfeist on December 23, 2022, 08:41:27 PM
How the heck did you print that in 1 hours 18 minutes??

:) An hour for 1... just put them all on the plate for a pic.

davidk

Quote from: GordPayne on December 23, 2022, 08:56:51 PM
The river and panel detail is great! Congrats!

Didn't design it... only printed it.  Designed by Troy McMillan.

davidk

Full nacelle, made up of the wing attachment section, the motor housing, and the motor cowl.

Michael

Michael

davidk

Pratt & Whitney Engines done.

davidk

I think I've decided to do a yellow fuselage.  It's not scale... but I can't see scale in the air.  Yellow I can see.
The second pic shows have the attachment area for the retract and the steering servo recess.

octagon

What could possibly go wrong?

davidk

Largest part of the wing... probably the longest print time... 11 hours.
Build in support for where the Nacelle and Retract goes.  Really excellent design for a tear away section that allows the rest of the wing to print properly.

davidk

Fuselage 2 with Fuselage 1 also showing the steering servo and front retract.

davidk

Full fuselage done... just taped together to get a sense of the size of this thing.  It's big.

Michael

Michael