Hello, I am starting to build a SIG Komander. I plan on installing a E-Flite 46 Outrunner motor, using 3300-4S battery.
I am looking for a template for the X-mount for the motor so I can drill and add the blind nuts without drilling through a motor mount.
The dimensions I came up with were 50mm centre to centre as per the attached picture.
Are these the correct dimensions for the E-Flite?
Thank you.
Guy O'Reilly
Guy,
Just pulled out my NIB E-Flite Power 46, the original instructions and my digital micrometer.*
Funny that the instructions do not contain the drawings and distances.
Distance between the firewall mounting holes centres- 56.0 mm (outer holes) Measured diagonally across the centre.
Distance between the motor mounting hole centres- 30.0 mm (inner holes). Measured diagonally across the centre.
The inner holes are symmetrical for the Power 46. Some motors are not.
Hope that helps.
Frank
* Bruce will be proud of me! ;D
Thank you Frank! :)
This helps.
I too was surprised :o to see that there were no template or dimensions shown in the instructions.
Guy