Had a chance to see a few awesome planes in the air. Stopped by to try out the bixler I got from Simon a while ago. It was nice to get out to the field a bit. 

The rear 2 sections of the main fuselage are made up of 4 printed parts... tops and bottoms.
The gold piece is a crossbar brace.  The carbon fibre tubes run through the fuselage and through this crossbar.
There are a lot of alignment tabs between these 2 sections.

Assembly started.

Wingspan 1400mm / 55.1 inches.  Printable in 2 versions, A or D, and with or without the sponsons on the sides of the fuselage.  I've printed the short nose A version with the sponsons.

Wingspan?

Time to start the Bronco.

To All Flyers,

Since the runway is still pliable and the forecast is dry today and tomorrow, I've arranged for a roller to be delivered to the field tomorrow morning with an ETA of 9am.

There will be no flying during most of the day tomorrow while we roll the runway.

Any help would be appreciated.

Regards,

David

Am planning to go to the annual Oakville /Milton swap meet.
Always something interesting to buy and old friends to see.

Frank


From the MAAC sanction:
Date: Sunday April 24, 2022 Time: 9:00am to 12:00 Noon

Location: CPEW Union Hall, located at 785 Pacific Road Units 13 and 14, Oakville, Ontario.

Fee for entry is $5. Free for adult-accompanied children under 13 years of age. Rental space for vendors is $15 per table. Tables sell out so vendors are urged to reserve theirs early!

Directions:
85 Pacific Rd, Oakville ON L6L 6M3, Units 13 & 14.
From the QEW take Exit 111 for Bronte Rd/Halton Regional Rd 25 S. Drive 350m to Wyecroft Rd and turn left. Drive 650m to Pacific Rd and turn left. Drive 220m and enter the industrial plaza at 785 Pacific Road on your right. Unit 13-14 is about halfway on your left.

Tail secured onto fuselage and hinged.

Radio, receiver and gyro/stabilizer installed.

Lower wing and main landing attached to the fuselage.