SOLD :)
Selling my TM Pro Bearcat. Model is a built balsa ARF with 35" wing span and 27" length. I was using a 3536 turnigy motor in it, with 50A esc on 3S 2200mAh lipo and getting around 450 watts. But it doesn't need this much to fly! I flew is maybe 5 times, but it wasn't for me.
Never crashed. However, the one bad bit is that it does have a tear in the wing covering, on the underside of the left wing (see photo) where the wind got in, under the covering film by the undercarriage block.
Tickler shows photo of actual model flying. Link to model is here:
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=7526 (http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=7526)
It has 3 x Corono (939MG I think) servos but needs rx, esc and motor.
Asking $50 without motor (or $60 with Turnigy D3536/6 1250kV)