Print Page - Motor did not respond

Title: Motor did not respond
Post by: Jatin on November 06, 2007, 06:44:40 AM

Hi ! everyone, I have Hobbico Electristar EP RTF 63".Yesterday I was taking a ground test for controls and I found that Radio is on connect the bateries,turn on the on switch and pull forward the throttle to arm the motor but I can't hear the beep sound. All other controls are working fine except motor. Unfortunately it can't arm after so many try. I checked wiring and reconnect it again but same thing.

Everyones guidence will be appreciated.

Thanks

-Jatin

Title: Motor did not respond
Post by: rkhoo on November 06, 2007, 11:06:00 AM

Bring o the EMFSO meet tommorrow nite and I am sure you will get lots of help.

If all wiring is good, including motor leads and ESC-RX wiring, then I would think your motor or ESC may be tossed.

How old is the motor and what battery/prop did you use?

Title: Motor did not respond
Post by: Jatin on November 06, 2007, 12:21:30 PM

Thanks for consolation [:(]

Battery : 7 Cell 8.4V 3000mAh NiMH

ESC : SS45D Brushless 45A ESC

Motor : 42mm out runner Brushless.

Title: Motor did not respond
Post by: Jatin on November 06, 2007, 12:23:13 PM

Well, It's a Brand new plane. Fly this plane only about 6-7 flights

Title: Motor did not respond
Post by: Jatin on November 06, 2007, 04:41:19 PM

Hey, Good news is found the problem and solve. Motor is running now but I don't know how to release the break on motor through ESC. Any idea ?
Everyone's guidence will be appreciated.
-Thanks

-Jatin

Title: Motor did not respond
Post by: Michael on November 06, 2007, 04:54:31 PM

As mentioned above, if you can bring it to the meeting on Wednesday evening, we can have a look at it.

Michael

Toronto Electric Model Aviation Club Forum

Toronto Electric Model Aviation Club (TEMAC) => General Discussion => Topic started by: Jatin on November 06, 2007, 06:44:40 AM