Print Page - How do I wire in a BEC, if all the channels on my receiver are taken?

Title: How do I wire in a BEC, if all the channels on my receiver are taken?
Post by: Eric Adventurer on May 16, 2016, 01:08:56 AM

How do I wire in a BEC, if all the channels on my receiver are taken?

Thanks guys,

Eric

Title: Re: How do I wire in a BEC, if all the channels on my receiver are taken?
Post by: pmackenzie on May 16, 2016, 06:16:04 AM

Y connector.

Pat MacKenzie

Title: Re: How do I wire in a BEC, if all the channels on my receiver are taken?
Post by: piker on May 16, 2016, 12:19:10 PM

I assume you could also use the binding port, but you'd have to move some plugs around when you need to bind.

Title: Re: How do I wire in a BEC, if all the channels on my receiver are taken?
Post by: Eric Adventurer on May 16, 2016, 11:07:03 PM

Thanks Pat and Rob, I just realized that I already had the throttle plugged in to the throttle port the BEC is plugged in to my Bind port.
I mixed myself up because the sticker on the receiver is not well being aligned with the pins. ;D

Toronto Electric Model Aviation Club Forum

Toronto Electric Model Aviation Club (TEMAC) => General Discussion => Topic started by: Eric Adventurer on May 16, 2016, 01:08:56 AM