This box of stuff will eventually become the FMA IA-58 PUCARA
I'm looking forward to seeing this very unusual plane
I've actually always liked this plane.
The Pucara motor mount is a structure built of 5 pieces and then glued onto the wing and gear support.
It's then covered with 6 parts to form a nacelle.
This build is less sophisticated than other printed planes. PlanePrint designs in a ton of guides and alignment parts to ensure a good fit. Only CA is needed for a PlanePrint plane. This plane has no alignment parts at all... so CA is out of the question. 5 min epoxy allows just the right amount of time for adjustment.