Old School Model Works Minuette build

[msatin]

3 coats of Stain. 2 of clear laquer.
Sanding and getting full coverage on the inside of the cross members was a real pain
Tail feathers have been covered in UltraCote

[Michael]

Looking great!

[msatin]

Covered Ailerons.
I'll give 3 guesess which one was done 1st. lol

[msatin]

Bottom of one wing half.
I can do the bottom of each half seperately before I glue the 2 halves to the center section.
I have to leave the tops uncovered while gluing, as I will have to use clamps to secure the halves to the center section.

[msatin]

Servos for tailfeathers are Pull-Pull.
One was installed upside down, the other right side up.
Access panels for both are built into the top and bottom of the fuselage

[msatin]

The actual setting up of the this system was easier than I thought, and Du-Bro has a good video for this

[msatin]

Side View of the exposed fuselage with the wires running to the tailfeathers

[msatin]

Other than installing the "for show" guide wires, the plane is now ready to fly with all electronics now installed and setup.
Yabba Dabba Doo!

[Frank v B]

Wow!  You found the finish line.
Yabba Dabba Did it!

Nice going.

Frank