Frank's re-build of a Knox Hawkshaw's design/build

[Frank v B]

Time to pull this one out again since the flying season is nearing an end*.

In the past week I have completed the following:
- set up the wing and drilled it for the wing bolts.  It now attaches properly and is lined up and square.
- installed the elevator and rudder servos in the fuselage.
- attached the aileron pushrod
- installed the aileron horns and made the pushrods
- had an accident.  The wing fell over and punched a hole through the top of the wing.  Watch the future "how to patch a hole in the wing" post.

Next steps- cover the fuselage.

Frank

* it is just starting for Andy.... but then... he has always been backwards.