Adding these two planes to the earlier message posted by Canuke.  I would like to get $300 for the complete package. I have been flying these Barons with four cells and they really fly.  One plane is complete ready to fly.  The second one uses the power pod from this plane. If this is not clear, please contact me, Jim Spence, directly.

Installing hinges.

The port aileron was ripped off.  The hinge point was in the middle of the aileron,
I used 3 hinges, removed the pin with a side cutter.  For purposes of this demonstration I have inserted a length of piano wire the width of the aileron.  The purpose of the wire is to show that the hinge pins of all 3 hinges need to be exactly in line on all dimensions.

Step 1- remove the pins from 3 hinges
Step 2- cut off the remaining foam that used to be the hinge on both the wing and the aileron.
Step 3- cut slots where the hinges are to be installed.  Note: I install the hinges on one side (wing), glue them in and let them cure.  Then do the same on the aileron side (tomorrow).  This allows everything to cure on one side.
Step 4- add a drop of oil on the hinge points.  This is so epoxy will not cure on it.  I spread it on the small hinge tabs with a toothpick.
Step 5- push 5 minute epoxy into each slot in the wing.  Wipe off excess.  Put glue on one half of the 3 hinges and insert them into the wing.  Make sure the piece of piano wire is absolutely straight.

So much for one side of the hinges.  Tomorrow the same will happen to the aileron.

Photos:
06- 3 hinges.  The right two have had the pins partially removed.
07- 3 hinges with a piece of piano wire holding them in place.
08- left hinge installed, middle hinge ready to be installed with glue.
09- 5 minute epoxy pushed into the last hinge slot.
10- all three hinges perfectly lined up.

Frank

Gluing the last large crack.

04- glued crack with round toothpicks inserted.
05- the toothpicks cut off with a side cutter.  Then the toothpicks are pushed in below the surface before the glue dries.

Frank

Hi everyone,
I have a Gravity Feed Airbrushing Kit with Dual Action Airbrush, compressor
With airbrush hose and international plugs, 3 speeds, comes with
an airbrush cleaning pot

I bought this kit in Dec. 2020 from Pinnacle for $249 plus tax

Anyone interested in this for $100.
It never got used. Still in original box. Brand New.

[email protected]

416-804-5512

I am in also put me as 2 and 4 dog's
Please let me know how much for my friend so I can charge him double   

Training tomorrow (Wednesday, May 29). I will be there no matter the weather.

Here's hoping many members can come out and play.


Frank

Fuselage

It's marked in my calendar.

A kennel's worth of dogs please.  (2)

Frank

Wings done, motors installed, counter rotating props.  Even the prop adapter screws are right and left handed.