Sr. Falcon EDF Power - Kit Bashing

[GuyOReilly]

Bad weather means more building time!
Covering completed.
Need to do:
1- fish wires through the wing for aileron servos
2- glue/epoxy the fin/stab
3- remove green tape
4- glue aileron hinges.
5- make pushrods for elevator, rudder and ailerons.
6- perform mandatory basement taxi test.


Photo #11 shaping wingtips.
Photo #15 wing covered.
Photo #16 assembled. 
Photo #17 other angle, I love the rudder!
Photo #18 and #19 EDF mounting on 2 layers of 1/8 plywood.  The ESCs are on the side, held in place with zipties.

[GuyOReilly]

IT IS ALIVE!!!!

https://www.youtube.com/watch?v=BteMr0whqbg

I just had to do taxi tests as per the challenge/request from @Frank v B .

Elevator and rudder need to be installed/epoxied in place. No aileron functions yet, but the servos are temporarily installed.

[GuyOReilly]

These 1964 decals were very brittle and difficult to place.
They still add a bit of flair.

[GuyOReilly]

Simple task: locate 2 identical control horns for ailerons (done) and 2 more for elevator and rudder... 
Preferably all 4 should be the same, but...