TEMAC

TEMAC Fall Field Maintenance – Oct 24 2015

Posted on October 25, 2015 by ahoffer

Posted in Galleries

« TEMAC Skills Challenge – Oct 18 2015

Annual Report from the President 2015 »

EZ Glider
April 7, 2020
Hi wanna buildersThat's you that want to build but .....balsa .... scary stuff.And your sitting watching these wonder builders.... and there great to watch.I've got a solution to get the creative mind going with out to much expense How about you b...
Field Repair
April 6, 2020
While the ground was still soft, but not wet, Glenn and I repaired the damage done to the grass area. Since it was damaged by a vehicle, it seems fitting that it was repaired by a vehicle.Being socially distant and aware, Glenn directed and I drove. ...
Gerald's Covid build - Guillow's FW 190 rubber band kit
April 6, 2020
Gerald's Christmas present was the new E-Flite Cherokee. Since he was off work he decided to put it together. His partner Diane who bought the present was disappointed because "The Cherokee went together with a few screws in about 12 minutes." Geral...
Unboxing and “building” the Piper Cherokee
April 4, 2020
Well, I’ve been at home from Home Depot’s Innovation Centre for the last week (we were deemed non-essential) and have caught up on the multitude of outstanding household chores. I can now turn my attention to the fleet of unbuilt and unrepaired airpla...
Full size molded fuselage
April 3, 2020
I stumbled on to this video of a gentleman fabricating a full size pylon racer and was really surprised how similar the techniques he used are to how we build for our hobby.
I am going to buy this!
April 2, 2020
https://www.horizonhobby.com/citation-longitude-bnf-basic-w-safe-select-eflu6350?utm_source=youtube.com&utm_medium=social&utm_campaign=efl_efl6350
Caution: Brushless motors on your work bench
April 1, 2020
Just had a close call with an E-Flite 180 brushless motor. It spun fine in my hand when I got it from the drawer. When I soldered on the connectors and connected it, it would not spin by hand.Looked at it under the magnifying glass and...
New project - West Wings Fournier RF4
March 31, 2020
This is a semi-scale model kit of a Fournier RF4, a motor-powered single person glider. The kit is about 10 years old, and is intended for a brushed 400 motor (I'm using brushless) and 3 channel operation. The wingspan is about 1500 mm (59"). The wood ...
OK - So I'm bored...
March 30, 2020
OK - So I'm bored already...
TEMAC Tickler - Coronavirus 2020
March 29, 2020
For the Well Being of our MembersAs before, I hope all of our members, friends and families are doing as well as possible.There have been a slew of emails being fired off between board members, and lots of discussion on the TEMAC website forum regard...